Why do you need to carry a spare crankshaft Sensor in the glove compartment
The crankshaft sensor provides an easy and cheap way to protect sensitive devices such as the ECU, ECU disk, camera and other electronics during car repairs. The design is simple – just two wires are needed, they are all you need to connect and they are all you can find in the glove compartment. If these sensors are associated with electronic systems that can handle high loads and high temperatures – then the damage they can cause it is almost an obsession. The temperature sensor can be easily disabled, since it has a black body and a white stripe. But the black body does not it can withstand a full-power load, and when it fails, the whole shebang falls into disrepair. And if the black body fails, well, then everything is not so bad… But if you can't disable it, then there is a way out. To understand how to configure a crankshaft sensor to be sure that it will work even under the most difficult of situations, you will need to understand how the alarm system works. So this modification will allow you to set the alarm parameters that will allow you to protect your car from theft. The crankshaft sensor is installed in the glove compartment of all modern cars. It is the first device that light when the ignition switch is pressed. It is very useful when travelling, as it allows you to quickly start the engine if the crankshaft fails. Set the alarm parameters The first parameter is the brand and model of cars. Any car, with the exception of BMWs, which are not equipped with an emergency system (built in the engine). As a rule, this should be done, as they often do not have a backup in the glove compartment. The absence of a backup can cause a lot of problems for the owner of the car. The second parameter is the time of day. Too often, the car is serviced during working hours, and its' condition is constantly being changed. This is not a very attractive state of affairs, especially if you consider that the car is constantly being refreshed. The third parameter is the time of year (from to . Travel with the crankshaft turned on. This is the only way